Eco-Etch Pro™ Concrete Etch & Clean Concentrate
Better. Safer. Faster.
Eco-Etch Pro™ is a water-based non-hazardous, non-corrosive, biodegradable concentrate concrete etcher and cleaning solution. It is the ideal acid etch alternative. This advanced formula incorporates a custom blend of surfactants, organic minerals and derivatives of a plant based extract for the most effective concrete etching solution available. The concrete etcher does not contain phosphoric, hydrochloric or muriatic acid, yet works better, safer and faster. Eco-Etch Pro™ is the preferred eco-friendly and user friendly acid etching alternative for interior or exterior surface preparation applications. The concrete etcher will not burn skin, corrode metals, or harm vegetation.
Clean and etch concrete, masonry, cinder block, brick, mortar joints and grout to properly prepare substrates for optimum penetration and adhesion of stains, paints, industrial coatings, and sealers. Eco-Etch Pro™ also removes dirt, clay, mortar deposits, rust and efflorescence. A one step concrete etch and clean solution that brings back a new look surface. Highly recommended for use with SoyCrete™ Concrete Stain and Eco-Tuff™ Coatings for optimum porosity and desirable results.
Eco-Etch Pro™ begins to work immediately upon contact without toxic hazards or dangerous skin burns associated with traditional acid formulas. Eco-Etch Pro™ should be used in full strength or diluted up to 3:1 (makes up to 4 gallons) with water for lighter cleaning and etching requirements as pre-tested for proper efficacy. One gallon will cover up to 200 square feet. Dwell time will vary from 1 to 15 minutes which is also affected by the dilution ratio, porosity, and temperature. Rinsing thoroughly with water neutralizes the etching action. Make sure the solution creates a reactive foam and remains wet during the etching process.
Product Data Sheet
Eco-Etch Pro PDS
Eco-Etch Pro Installation Guide
Safety Data Sheet
Eco-Etch Pro SDS
"How to Video Series"
1. How to Properly Etch Concrete